RS8R-MKII

  • The RS8-R is a Relay switching unit with 8 inputs for connection of 8 amplifiers, 2 inputs for connecting the back-up amplifiers and 8 output lines.
  • The 8 output lines are normally connected directly to the inputs, so to the outputs the primary amplifiers.
  • In case of failure on an amplifier, through serial commands or logic inputs, you can disconnect the line of this amplifier and connect it to the backup amplifier.
  • The module can handle up to two amplifiers, each of which is available for 4-lines input-output.
  • The first backup amplifier (Spare A) is associated to lines 1-4, while the second backup amplifier (Spare B) to lines 5-8.
  • If there’s a single backup amplifier, you can handle the switching of all 8 lines to one amplifier simply by connecting in parallel the inputs Spare A and Spare B.
  • In order to verify a correct serial communications the transmission system can do polling at predetermined intervals (< 2 sec) of the
  • RS8-R, so in case of wrong string reception it will indicate the no communication error.
  • The device can be controlled through serial communication according to the standard RS-232 or RS-485.
  • For each module RS8-R a unique address (ID) can be configured by a dipswitch, with values in the range 1-255, for the purpose of multi-device control on RS-485 bus.
  • Thanks to the internal microcontroller on the front panel is indicated by LEDs the activation status of individual channels and the presence of possible errors.
  • RS8-R can handle an amplifier up till 600 watts of power, for low impedance loads (4-8 Ohm) or constant voltage 70-100 Volt loads (the type of backup  amplifiers must be the same of the main amplifiers).
  • However you can handle two different types of amplifiers using separate backup inputs Spare A and Spare B.
  • The device is powered at 110 or 230 Volt AC, selectable by an internal switch.
  • The input and output terminals with screw are removable and can accept cables with 4 mm2 maximum section.
  • Detachable front panel module for convenient rack 19”  mounting and management.

Technical Features

Switching Lines: 8

  • Lines 1- 8 with inserting on SPARE A B
  • Lines 1- 4 with inserting on SPARE A
  • Lines 5- 8 with inserting on SPARE B
Max power for 4-8 ohms lines amplifiers: 600 watts
Max power for 70-100V lines amplifiers: 800 watts
Control:
  • RS-232
  • RS-485
  • 8 optoisolated logic contacts
Addressable Units: Addressable Units: up till 256
Power Supply: Integrated
Connections:
  • Line 4 mm removable clamps
  • Logic inputs 1,5mm. removable clamps
Frontal Leds:
  • Power ON/OFF
  • RS-232 / RS-485 Communication
  • Internal Fault
  • Backup Line Activation (yellow)
  • Relay switching Fault (red)
Fault warning::
  • Output relay clear contact – Generic fault<
  • Serial communication Rs-232 / RS-485
Dielectric strength: 4kv
AC Mains: 110-230 volt (Internally selectable)
CEE Directive Compliant:
  • Safety (LVD): EN 60065:202+A1:2006
  • Electromagnetic Compatibility (EMC):
    EN 55103-1:1998 Enviroment E2
    EN 55103-2:1998 Enviroment E2
Size: 1 rack unit 44mm (H) x 440mm (W) x 170mm (D)
Peso: 1.9 kg
Color: black